开发工具
调试仿真
STLINK 调试器

ST-LINK

    in-circuit debugger/programmer for STM8 and STM32


    Introduction

    The ST-LINK is an in-circuit debugger and programmer for the STM8 and STM32

    microcontroller families.

    The SWIM / JTAG interface is used to communicate with the STM8 or STM32

    microcontroller located on your own application board.

    On the PC side, the USB full speed interface is used to communicate with:

    ●   ST Visual Develop (STVD) or ST Visual Program (STVP) software from

    STMicroelectronic's for the STM8,

    ●   IAR and KEIL Integrated Development Environment for the STM32.

 Features

    ●   5V power supplied by USB connector.

    ●   USB 2.0 full speed interface compatible.

    ●   USB standard A to Mini-B cable provided.

    ●   SWIM specific features:

    –   1.65V to 5.5V application voltage supported on SWIM interface.

    –   SWIM low speed and high speed modes supported.

    –   SWIM programming speed rate:

    9.7Kbytes/s in low speed,

    12.8Kbytes/s in high speed.

    –   SWIM cable provided for connection to an application with an ERNI standard

    connector vertical (ref: 284697 or 214017) or horizontal (ref: 214012).

    –   SWIM cable for connection to an application with pin headers or 2.54mm pitch

    connector.

    ●   JTAG specific features:

    –   3V to 3.6V application voltage supported on JTAG interface and 5V tolerant

    inputs.

    –   JTAG cable provided for connection to a standard JTAG 20-pin pitch 2.54mm

    connector.

    ●   Direct firmware update feature supported (DFU).

    ●   Status LED which blinks during communication with PC.

    ●   Operating temperature 0 to 50°C.

地址:深圳市南山区桃园路西海明珠大厦F座511-517
电话:0755-23050055 传真:0755-27389009